10. Remove the entire hydrostatic
transmission cable.
Fitting the Hydrostatic
Transmission Cable
1.
Screw in the front link joint on the new
hydrostatic transmission cable and
tighten the lock nut.
2.
Run the cable through the rider so that it
follows the same path as the old cable
did.
3.
Make sure that the cable is routed under
the articulated steering bearing as
shown in the picture. On page 47 a view
from the right is shown. The placement
of the cable is important otherwise the
pump stroke can be affected when you
turn in either direction.
4.
Press in the cable casing in the forward
fastener in the centre bracket.
58
English-
REPAIR INSTRUCTIONS
Remove the hydrostatic transmission cable.
Front link joint
Under the articulated steering bearing
Forward mount in centre bracket