Fitting The Hydrostatic Transmission Cable - Husqvarna Rider PR 17 Workshop Manual

10. Remove the entire hydrostatic
transmission cable.
Fitting the Hydrostatic
Transmission Cable
1. Screw in the front link joint on the new
hydrostatic transmission cable and
tighten the lock nut.
2. Run the cable through the rider so that it
follows the same path as the old cable
did.
3. Make sure that the cable is routed under
the articulated steering bearing as
shown in the picture. On page 47 a view
from the right is shown. The placement of
the cable is important otherwise the
pump stroke can be affected when you
turn in either direction.
REPAIR INSTRUCTIONS
Remove the hydrostatic transmission cable.
Front link joint
1
2
Threading the cable
Under the articulated steering bearing
63
English-