9.
Remove the entire hydrostatic transmis-
sion cable.
Fitting the Hydrostatic Transmission
Cable
1.
Screw in the front link joint on the new
hydrostatic transmission cable and
tighten the lock nut.
2.
Run the cable through the rider so that it
follows the same path as the old cable
did.
3.
Make sure that the cable is routed under
the articulated steering bearing as
shown in the picture. The placement of
the cable is important otherwise the
pump stroke can be affected when you
turn in either direction.
REPAIR INSTRUCTIONS
Remove the hydrostatic transmission cable.
Front link joint
Threading the cable
Under the articulated steering bearing
69
English-