Husqvarna R 422 Ts Workshop Manual page 85

Hide thumbs Also See for R 422 Ts:
Table of Contents

Advertisement

7.
Mark one end of the shaft. Push out the
shaft with a puller. Tap out the bearing
and remove the spacer.
You can purchase the entire assembly,
complete with shaft housing, shaft, spacer,
and bearings.
Fit in the reverse order to removal. Make sure
that the shaft is mounted in the same
direction as when it was removed, otherwise
the keys will not fit the grooves.
IMPORTANT INFORMATION
When tightening the blade shaft screws,
the transmission side should always be
tightened first and then the blade screws.
Tighten the blade bearings with a torque of
20-25 Nm (14-18) lbf. ft.
Tighten the blade bolts with a torque of 45-50
Nm (32-36) lbf. ft.
REPAIR INSTRUCTIONS
Repair kit
83
English-

Advertisement

Table of Contents
loading

This manual is also suitable for:

R 422 ts awd

Table of Contents