Table of Contents
Advertisement
5.
Tighten the hydrostatic transmission
cable clamp. Press the link joint onto its
fastener and attach the locking spring.
6.
Attach the link joint to the rear part of the
hydrostatic transmission cable.
Screw 10-12 turns so that the link joint
has the right length.
7.
Run the hydrostatic transmission cable
along with the other cables.
8.
Position the hydrostatic transmission
cable in the casing's rear bracket.
9.
Adjust the hydrostatic transmission cable
as shown, see "Adjusting the Hydrostatic
Transmission Cable" on page 41.
10. Connect the rear link joint and attach the
locking spring.
11. Tighten the rear link joint's lock nut.
12. Check the settings of the neutral position
contact. See "Micro Switch Pedal
Arrangement" on page 103.
REPAIR INSTRUCTIONS
Front clamp
Rear link joint
Adjusting the hydrostatic transmission cable
Locking spring
59
English-
Advertisement
Table of Contents
