Table of Contents
Advertisement
4. CONFIGURATION
4.8.5.
SWTCH - Output cycle limit alarm
Acronym
SWTCH
NUMBER OF SWITCHING CYCLES
The parameter shows and sets the number of cycles (x1000) of the relay, exceeding which the signal is generated OUTX.
SWITCH ALARM where X is the number of output 1 or 2 or 3 or 4 if the output is relay, logic or triac.
The function is disabled if the parameter equals "0".
Unit of measurement:
Options:
0...9999
4.8.6.
FAULT - State of output with broken input
Acronym
FAULT
FAULT OUTPUT STATE
The parameter shows and sets the state (on, off) that the output assumes in case of broken input (Err, Sbr, ...), if the
output is direct or inverse.
Unit of measurement:
Options:
OFF
On
4.8.7.
MSG.OU - Selecting the output message
Acronym
MSG.OU
NUMBER OF SCROLLING MESSAGE AT OUTPUT ACT
The parameter shows and sets the number of the message assigned to activation of the output, i.e., the scrolling messa-
ge shown on the display.
For more information on scrolling messages, see paragraph "3.1.2.2. Scrolling messages" on page 24.
If the parameter is set to "0" no message will be displayed when the output is activated.
The same message number can be assigned to different outputs.
Unit of measurement:
Options:
0...25
Scrolling message
Number
Scrolling message
-
= Output is off
= Output is on
Scrolling message
Message number
80224_MHW_650 L - 1250 L_07-2018_ENG - 54
Submenu
Attributes
OUTPU
R W
Submenu
Attributes
OUTPU
R W
Submenu
Attributes
OUTPU
R W
Advertisement
Table of Contents
