Blk.al - Flashing Of Pv Display; Blk.an - Pv Display Alarm Flashing With Alarm Reset - gefran 650 L Installation And Instruction Manual

4.6.11. BLK.AL - Flashing of PV display

Acronym
BLK.AL BLINK DISPLAY PV DEF
The parameter shows and sets the flashing of the PV display in case of alarm, for the alarm being configured.
If the parameter is "On," the value shown on the PV display starts to flash in case of alarm.
The parameter only appears for ALARM=2, ALARM=3 and ALARM=4.
Only On for Alarm 1
Unit of measurement:
Options: OFF
On

4.6.12. BLK.AN - PV display alarm flashing with alarm reset

Acronym
BLK.AN BLINK DISPLAY PV DEF AT ALARM DISACT
The parameter controls the optional blinking of the PV value display with regard to latched alarms. The parameter sets PV
display flashing in the case when the alarm is no longer active, but has been latched from prior triggering, but has not yet
been cleared from memory.
If the parameter is "On", the value displayed on the PV display flashes.
The parameter only appears for ALARM=2, ALARM=3 and ALARM=4.
Only OFF for Alarm 1
The parameter only appears if LATCH=On or OnOF.
Unit of measurement:
Options:
Scrolling message
-
= PV display does not flash in case of alarm
= The PV display flashes in the event of alarm
Scrolling message
-
OFF = The PV display does not flash
On = The PV display flashes
80224_MHW_650 L - 1250 L_07-2018_ENG - 49
4. CONFIGURATION
Submenu Attributes
ALARM R W
Submenu Attributes
ALARM R W