U.cal - Selecting The User Calibration; Cal - Resetting The Factory Calibration; C.low - Calibrating Minimum Current / Voltage; C.high - Calibrating Maximum Current / Voltage - gefran 650 L Installation And Instruction Manual

4. CONFIGURATION

4.14.1. U.CAL - Selecting the user calibration

Acronym
U.CAL USER CALIBRATION TYPE
The parameter shows and sets the parameter, input or output to which calibration will be applied.
Unit of measurement:
Options:
4.14.2. FI.CAL - Resetting the factory calibration
Acronym
FI.CAL FACTORY CALIBRATION
The parameter shows and sets resetting of the factory calibration.
This operation can be done only for inputs and outputs, if U.CAL corresponds to I.MAIN, OUT.A1.
Unit of measurement:
Options: NO
YES

4.14.3. C.LOW - Calibrating minimum current / voltage

Acronym
C.LOW
The parameter appears if you are calibrating a custom I.MAIN input in current or voltage.
To calibrate:
• apply the current or voltage value corresponding to minimum scale value to the selected input;
• press the key to acquire the calibration value.
Unit of measurement:
Options: -

4.14.4. C.HIGH - Calibrating maximum current / voltage

Acronym
C.HIGH
The parameter appears if you are calibrating a custom I.MAIN input in current or voltage.
To calibrate:
• apply the current or voltage value corresponding to maximum scale value to the selected input;
• press the key to acquire the calibration value.
Unit of measurement:
Options:
-
Scrolling message
-
NONE = No calibration
P.DAYS = Reset partial day count
I.MAIN = Calibration of custom main input (selected with parameter tyPE on I.MAIN menu)
OUT.A1 = Custom re-transmission output calibration (selected with parameter t.o.A1 in menu
OUT.AN)
Scrolling message
-
= Keep user calibration
= Reset factory calibration
Scrolling message
-
Scrolling message
-
80224_MHW_650 L - 1250 L_07-2018_ENG - 68
Submenu Attributes
US.CAL R W
Submenu Attributes
US.CAL R W
Submenu Attributes
US.CAL R W
Submenu Attributes
US.CAL R W