Hi.scl - Upper Limit Of Scale; Of.scl - Scale Offset Correction; Lo.al - Lower Limit For Alarms; Hi.al - Upper Limit For Alarms - gefran 650 L Installation And Instruction Manual

4. CONFIGURATION
4.5.9.

HI.SCL - Upper limit of scale

Acronym
HI.SCL INPUT HIGH LIMIT
The parameter shows and sets the upper limit of the measurement scale used for the main input, based on input (or sen-
sor) type, engineering units, and number of decimals selected.
The lower value of HI.SCL is limited by the value of LO.SCL.
Unit of measurement:
Options: A value in the interval corresponding to the input or sensor type (see tables for LO.SCL parameter).

4.5.10. OF.SCL - Scale offset correction

Acronym
OF.SCL INPUT OFFSET
The parameter shows and sets the offset applied to the value read in input to make it correspond to the expected value
for a certain temperature. It corrects any constant read error of the sensor.
This offset is applied linearly to all reads; therefore it cannot be used to correct any sensor linearity errors.
Unit of measurement:
Options: -999...999

4.5.11. LO.AL - Lower limit for alarms

Acronym
LO.AL LOW LIMIT FOR ABSOLUTE ALARMS
The parameter shows and sets, the minimum value for setting an alarm.
Unit of measurement:
Options: -1999...9999

4.5.12. HI.AL - Upper limit for alarms

Acronym
HI.AL HIGH LIMIT FOR ABSOLUTE ALARMS
The parameter shows and sets the upper limit for defining alarms, i.e., the maximum value for setting an alarm.
Unit of measurement:
Options: -1999...9999
Scrolling message
The one set with the Unit parameter
Scrolling message
The one set with the Unit parameter
Scrolling message
The one used for the alarm limit.
Scrolling message
The one used for the alarm limit.
80224_MHW_650 L - 1250 L_07-2018_ENG - 44
Submenu Attributes
I.MAIN R W
Submenu Attributes
I.MAIN R W
Submenu Attributes
I.MAIN R W
Submenu Attributes
I.MAIN R W