I.dig.n - Selecting The Digital Input; S.in.x - Defining The Input State; F.in.x - Selecting The Assigned Function; Msg.in - Selecting The Digital Input Message - gefran 650 L Installation And Instruction Manual

4.7.1.

I.DIG.N - Selecting the digital input

Acronym
I.DIG.N DIGITAL INPUT NUMBER
The parameter shows and sets the identifying number of the digital input to be configured.
Unit of measurement:
Options: 1...5
4.7.2.

S.in.x - Defining the input state

Acronym
S.in.x DIGITAL INPUT STATUS
The parameter shows and sets the state of the input with identifying number "x".
The direct digital input is active when there is current in the digital input or the contact is closed.
The inverse digital input is active when there is no current in the digital input or the contact is open.
Digital inputs can be forced so that they are always on or off.
Unit of measurement:
Options: DIREC = Direct digital input
INVRS
OFF
ON
4.7.3.

F.in.x - Selecting the assigned function

Acronym
F.in.x DIGITAL INPUT FUNCTION
The parameter shows and sets the function assigned to the digital input with identifying number "x".
Unit of measurement: -
Options: NONE
AL.ACK
FKEY
PK.RES
AL.PK.A
TM.AL1
CN.AL1
TC.AL1
4.7.4.

MSG.IN - Selecting the digital input message

Acronym
MSG.IN NUMBER OF SCROLLING MESSAGE AT INPUT ACT
The parameter shows and sets the number of the message assigned to activation of the digital input, i.e., the scrolling
message shown on the display.
For more information on scrolling messages, see paragraph "3.1.2.2. Scrolling messages" on page 24.
If the parameter is set to "0" no message will be displayed when the digital input is activated.
The same message number can be assigned to different inputs.
Unit of measurement:
Options: 0...25
Scrolling message
Number
for model 1250 L with 5 digital inputs option
Scrolling message
-
= Inverse digital input
= Digital input forced off
= Digital input forced on
Scrolling message
= No assigned function
= Reset alarm latches
= Block F key
= Maximum, minimum and peak-peak reset
= Alarm latch + maximum, minimum peak and peak-peak reset
= ALARM1 timer reset
= ALARM1 meter reset
= ALARM1 timer and meter reset
Scrolling message
Message number
80224_MHW_650 L - 1250 L_07-2018_ENG - 51
4. CONFIGURATION
Submenu Attributes
I.DIGT R W
Submenu Attributes
I.DIGT R W
Submenu Attributes
I.DIGT R W
Submenu Attributes
I.DIGT R W