Table of Contents
Advertisement
4. CONFIGURATION
The fast configuration described in the previous chapter lets
you rapidly put the indicator into operation.
To do this, the procedure configures the indicator's main pa-
rameters only, which satisfies the most common application
requirements.
On the other hand, to satisfy all application requirements
and to configure the indicator in detail, you have to set the
parameters that are accessible only on the Programming/
Configuration menu.
4.1.
Programming/Configuration Menu
4.1.1.
First: know what you're doing
Correctly setting the parameters needed to configure the in-
dicator requires thorough knowledge of the problems and
techniques involved.
If you are unsure of your know-how, or are not fully aware
of the consequences of incorrectly setting the parameters,
we advise you not to configure the indicator with this menu.
Attention! To prevent harm to persons and dama-
ge to property, the user must check that the para-
meters are correctly set before commissioning the
indicator.
In case of doubts, or if you need any explanations,
please consult www.gefran.com or contact Gefran
Customer Care.
4.1.2.
Passwords
The configuration menu is protected by 2 passwords that
allow access to two different menu sections.
The first section, accessed with password 1, groups the
most operative submenus and parameters, i.e., the ones
most involved in daily functioning of the controlled machine
or system.
The second section, accessed with password 2, groups the
submenus and parameters used to configure HW resources
The factory password settings are:
•
Password 0 = 10
•
Password 1 = 1
•
Password 2 = 2
The passwords can be changed and even disabled if you
want. See paragraphs on page 71 "4.15. PASC0 – Setting
level 0 password"; "4.16. PASC1 - Setting level 1 pas-
sword"; "4.17. PASC2 - Setting level 2 password".
4.
CONFIGURATION
80224_MHW_650 L - 1250 L_07-2018_ENG - 30
This type of configuration is also useful for optimizing per-
formance.
The indicator can be configured with the buttons on its panel
and from the PC with GF_eXpress software (see chapter "6.
Programming with PC" on page 75).
4.1.3.
Password in the User Menu
Two passwords can be entered in the User menu, respecti-
vely:
- Password 0 (default = 0)
- Password 1 (default = 1)
to inhibit navigation to parameters in positions subsequent
to that assigned to the password.
Once one of the two passwords is reached:
- if the entered value matches that expected, navigation
continues in the User Menu
- if the entered value does not match that expected, the
Home screen will be displayed
Advertisement
Table of Contents
