Gerber Technology AccuPlot AP-100 User Manual page 64

AccuPlot and AccuJet Maintenance
7. Attach the paper to the take-up roll:
•
•
•
8. Restart the plotter and advance the paper:
•
•
•
•
5-8
Unfold the point of the paper and trim the end with a utility
knife.
Fasten the paper to the cardboard take-up tube with masking
tape in three places: center, left, and right.
Turn the take-up roll bar to take up any slack. Lower the paper
grips.
Make sure the sliding covers are closed. Also, check that the
carriage is not all the way to either end of the beam or table.
Press F2-Resume from the Servo Disable menu to restart the
plotter. Use the Menu key to display page one of the Offline
menu.
From page one of the Offline menu, press F3-Paper Adv to
display the Paper Advance menu.
Press F1 two times to advance the paper onto the take-up roll.
Loading Plotter Paper