Gerber Technology AccuPlot AP-100 User Manual page 33

Offline Operation
T
O VIEW THE CURRENT SETTING FOR A PARAMETER
1. Follow the procedure beginning on page 4-12 to display the Chg Param
menu page that lists the parameter type you want.
2. Press the key associated with the parameter type to display the first
parameter setting of the group.
T
O CHANGE A SETTING
1. Use the left and right arrow keys to position the cursor on the digit you
want to change.
2. Press the up arrow key to increase the value of that digit, press the down
arrow key to decrease the value. Repeat this for each digit you want to
change.
3. Press F3-S
positive.
4. When you have completed your changes, press the Enter key to record
the new value.
NOTE: You must press Enter to record the new value, or the parameter will not
be changed.
If the value you enter is outside the limits for that parameter, (too
high or too low) the message Range Error appears in the display
window. Although the invalid value remains on the display, it will be
rejected by the plotter. To clear the message, raise or lower the
value and press the enter key again.
5. Do one of the following:
Plotter Parameters
PARAMETER NAME
NEXT PARAM
PREV PARAM
to change a positive value to negative or a negative value to
IGN
•
Press F1-N P
EXT ARAM
•
Press F2-P P
REV ARAM
•
Press F4-E to return to the Chg Param menu.
XIT
SIGN +/-
to go to the next parameter.
to return to the previous parameter.
EXIT
4-13