Ptz Configuration; Configuring Basic Ptz Parameters - HIKVISION DS-2DB4236I-CWX User Manual

9. Click

5.4 PTZ Configuration


On the event configuration page, click

Click the direction buttons to control the pan/tilt movements.

Click the zoom/iris/focus buttons to realize lens control.

The functions vary depending on different camera models.

5.4.1 Configuring Basic PTZ Parameters

Purpose:
You can configure the basic PTZ parameters, including Zoom speed and Power Off Memory.
Steps:
1. Enter the Basic Settings interface:
Configuration > PTZ > Basic Settings
2. Configure the following settings:
 Zooming Speed: The zoom speed is adjustable from level 1 to 3.
 Power-off Memory: The zoom camera can resume its previous PTZ status or actions after it
restarted from a power-off. You can set the time point to which the dome resumes its PTZ
status. You can set it to resume the status of 30 seconds, 60 seconds, 300 seconds or 600
seconds before power-off.
3. Click
© Hikvision
to save the settings.
to show the PTZ control panel or click
Figure 5-23 Basic Settings
to save the settings.
to hide it.