Configuring Video Tampering Alarm - HIKVISION DS-2DB4236I-CWX User Manual

Note:
You need a FTP server and set FTP parameters first. Refer to Section 6.1.2 Configuring
FTP Settings for setting FTP parameters.

5.2.2 Configuring Video Tampering Alarm

Purpose:
You can configure the camera to trigger the alarm actions when the lens is covered.
Steps:
1. Enter the Video Tampering settings interface :
Configuration > Event > Basic Event > Video Tampering
2. Check the checkbox to enable the tampering detection.
3. Set the tampering area.
4. Set Sensitivity level. Higher level means easier to trigger.
5. Click
schedule configuration is the same as the setting of the arming schedule for motion detection.
Refer to Section 5.2.1 Configuring Motion Detection.
6. Click
surveillance center, send email and trigger alarm output are selectable. Refer to Section 5.2.1
Configuring Motion Detection.
© Hikvision
Figure 5-15 Tampering Alarm
tab to enter the arming schedule setting interface. The arming
tab to select the linkage method taken for tampering. Notify