Table of Contents
Advertisement
8. Click
5.2.4 Configuring Alarm Output
Note:
The function is only supported by certain camera models.
Steps:
1. Enter the Alarm Output settings interface:
Configuration> Event > Basic Event > Alarm Output
2. Select one alarm output channel in the Alarm Output dropdown list.
3. Set a name in
(optional).
4. The Delay time can be set to 1sec, 5sec, 10sec, 30sec, 1min, 2min, 5min, 10min or Manual.
The delay time refers to the time duration that the alarm output remains in effect after alarm
occurs.
5. Click
configuration is the same as the settings of the arming schedule for motion detection. Refer
to Section 5.2.1 Configuring Motion Detection for more details.
© Hikvision
to save the settings.
Figure 5-17 Linkage Method
tab to enter the arming schedule setting interface. The time schedule
for the alarm output
Advertisement
Table of Contents
