2. Set the RS-485 parameters and click
Note:
The Baud rate, PTZ Protocol and PTZ Address parameters of the camera should be exactly the
same as those of the control device.
About
Click View License, you can check Open Source Software Licenses.
6.4.2 Maintenance
Upgrade & Maintenance
Rebooting the Camera
Steps:
5. Enter the Maintenance interface:
Configuration > System > Maintenance > Upgrade & Maintenance:
6. Click
Restoring Default Settings
Steps:
1.
Enter the Maintenance interface:
Configuration > System > Maintenance > Upgrade & Maintenance
2. Click
Note:
Clicking
address and user information. Use this button with caution.
© Hikvision
Figure 6-49 RS-485 Settings
to reboot the network camera.
or
restores all the parameters to default settings including the IP
to save the settings.
to restore the default settings.