Adj Led Rc2 Operation - ADJ ENCORE PROFILE 1000 WW User Instructions

ADJ LED RC2 OPERATION

The ADJ LED RC2 infrared remote (sold seperately) has many different functions to control your Encore
Profile 1000 WW. To control the fixture you must aim the controller at the infrared sensor and be no more the
30 feet away. To use the ADJ LED RC2 you must first activate the fixtures infrared sensor, to activate the
sensor please see the instructions on page 8.
BLACKOUT - Pressing this button will blackout the fixture.
SELECT PROG - Pressing this button will activate fade mode. Press the "+" or "-" buttons to adjust the running
speed.
FLASH - This button will activate the strobe effect. You can control the flash rate by pressing the "+" and "-"
buttons. Press the White button again to exit strobing mode.
SPEED - This button is invalid for this fixture.
DMX MODE - This button will cycle between DMX addressing, DMX channel mode, and dimmer curve
selection. Some fixtures will come with different DMX channel modes. This button will switch between the
different modes. Please see page 11 for DMX modes, values, and traits.
SLAVE/SOUND ACTIVE - This designates the fixture as a slave fixture in a master/slave configuration. Sound
activity is invalid for this fixture.
SET ADDRESS - Press this button to set the DMX address. Press this button first, then press the numbers to
set the address. If the address is correctly set, the LED will flash and the unit will automatically go into DMX
mode.
Set DMX Address 1 Press "S-0-0-1"
Example:
Set DMX Address 245 Press "S-2-4-5"
R G B W - Buttons R G B are invalide for this fixture. Press White button and the use the "+" or "-" to adjust the
output intensity. Press the FLASH button to activate strobing and use the "+" or "-" to adjust the flash speed.
"+" and "-" - These buttons adjust the flash rate, speed of the fade mode, and output intensity.
DMX Mode:
Operating through a DMX controller gives the user the freedom to create their own programs tailored to their
own individual needs. Follow the directions below to set your DMX address, DMX channel mode, and dimmer
curve mode.
1. Before connecting to a DMX controller, your fixture has different DMX channel modes, please select your
desired mode by pressing the DMX Mode button, and use the "+" or "-" buttons to scroll through the DMX
channel modes. Set the mode before you address the fixture. See below for the different DMX modes.
2. Press this button again to enter dimmer curve selection and use the "+" or "-" buttons to scroll through the
dimmer curve modes.
3. After you have selected your mode, set the DMX address for the fixture by pressing the "S" button. When
the "S" button is pressed the LED's will flash 2-3 times. Use the number buttons to press in your desired
address. See "SET ADDRESS" on page 10 for examples.
Note: When setting the DMX address each time a number is pressed a LED color will flash, when you have
set the DMX address correctly all LED's will flash 2-3 times.
4. Now you may connect the fixture via the XLR connections to any standard DMX controller. Please see page
11 to for a detailed descriptions of the DMX modes, values, and traits.
• If the White LED flashes 1 time you are in 1 Channel Mode.
• If the White LED flashes 2 times you are in 2 Channel Mode.
• If the White LED flashes 3 times you are in 3 Channel Mode.
A.D.J. Supply Europe B.V. – www.americandj.eu – Encore Profile 1000 WW Instruction Manual Page 10