ADJ ENCORE PROFILE 1000 WW User Instructions page 8

OPERATING INSTRUCTIONS (continued)
• 2 - TV
• 3 - Architectural
• 4 - Theatre
3. Press the UP or DOWN buttons to scroll through and select your desired dimming curve.
DMX State:
This mode can be used as a precaution mode, that in case the DMX signal is lost, the operating mode chosen
in the setup is the running mode the fixture will go into when the DMX signal is lost. You can also set this as
the operating mode you would like the unit to return to when power is applied.
1. Plug the fixture in and press the MODE button until "DMX MODE ADDR:XXX" is displayed.
2. Press the SET UP button until "DMX MODE NO" is displayed. The current DMX state will be displayed.
• "BLACK" (Blackout) - If the DMX signal is lost or interrupted, the unit will automatically go into stand by mode.
• "HOLD" (Last State) - If the DMX signal is lost or interrupted, the fixture will stay in the last DMX set up.
• "AUTO" (Auto Run) - If the DMX signal is lost or interrupted, the unit will automatically go into Auto Run
mode.
3. Press the UP or DOWN buttons to scroll through and select your desired DMX state.
IR Receiver On/Off:
This function is used to activate and deactivate the infared sensor. When this function is activated you can
control the fixture using the ADJ LED RC2 (sold separately), UC IR (sold separately), and Airstream IR app.
Please see pages 10-11 for remote controls and functions. To control the Encore Profile 1000 WW, plug the
included IR receiver into IR receiver input located on the rear of the controller. You must aim the remote at the
IR sensor and be no more the 30 feet away.
1. Plug the fixture in and press the MODE button until "OTHER MODE" is displayed.
2. Press the SET UP button until "IR: XX" is displayed.
3. Press the UP or DOWN buttons to either activate the remote function (On) or deactivate it (Off).
Gamma:
This feature is predominately used when shooting video. Adjust the gamma setting to clean up any lines that
might be seen on camera.
1. Plug the fixture in and press the MODE button until "GAMMA" is displayed. The current gamma setting will
be displayed.
2. Use the UP and DOWN buttons to switch the gamma setting.
Refresh Rate:
This feature is predominately used when shooting video. Adjust the frequency setting to clear up any LED
flicker that might be seen on camera.
1. Plug the fixture in and press the MODE button until "FREQUENC" is displayed. The current frequency
setting will be displayed.
2. Use the UP and DOWN buttons to switch the frequency setting.
PCB Temperature:
This will check the current temperature of unit as well as switch between fahrenheit and celsius.
1. Plug the fixture in and press the MODE button until "OTHER MODE" is displayed.
2. Press the SET UP button until "TEM:XXXX" is displayed.
3. Use the UP and DOWN buttons to switch between fahrenheit and celsius.
A.D.J. Supply Europe B.V. – www.americandj.eu – Encore Profile 1000 WW Instruction Manual Page 8