Cad Drawing; Adj Rfc Operation - ADJ COB CannOn Wash DW User Instructions

Master-Slave Connections and Settings:
1. Daisy chain your units via the XLR connector on the rear of the unit. Use standard XLR data cables to link
your units together. Remember that the Male XLR connector is the input and the Female XLR connector is the
ouput. The first unit in the chain (master) will use the female XLR connector only. The last unit in the chain will
use the male XLR connector only.
2. Set the "Master" unit to your desired mode of operation.
3. On the "Slave" units press the MODE button until "SLAu" is displayed. Each "Slave" unit must be set to the
same setting.
4. Connect the first "Slave" unit to the "Master." The "Slave" unit(s) should now start following the "Master" unit.

CAD DRAWING

ADJ RFC OPERATION

ADJ Products, LLC - www.adj.com COB Cannon Wash DW User Manual Page 11