Table of Contents
Advertisement
U C I R R E M O T E
The UC IR (sold separately) infrared remote gives you control of various functions, as listed below.
The remote must be aimed towards the front of the fixture, and maximum range is 30 feet.
CONTROLS
•
STAND BY - Press this button to blackout the fixture. Press the button again to return to the initial
state. This button is also used to switch between full on mode, 3.3W mode, and energy saving
mode. Refer to the Operating Instructions section of this manual for details.
•
FULL ON - Hold this button down to fully illuminate the unit. The unit returns to its previous state
when the button is released.
•
FADE/GOBO - Press to activate color fade mode.
•
"DIMMER +" and "DIMMER -" - Use these buttons to adjust the color output intensity when static
color mode is active.
•
STROBE - Press and hold for strobing.
•
COLOR - Press to activate static color mode. Use buttons 1-9 to select your desired color.
•
1-9 - Use to select your desired color in static color mode, or your desired show when show mode
is active.
•
SHOW 0 - Press this button to activate show mode, and use buttons 1-4 to select fast color fade,
fast color change, slow color fade, or slow color change modes.
A D J L E D R C 2 R E M O T E
The ADJ LED RC2 infrared remote (Sold Separately) has a wide range of functions, giving the
user complete control of the PinPoint Gobo COLOR. The controller must be aimed at the front of the
fixture, and maximum range is 30 feet.
CONTROLS
•
BLACKOUT - Press to blackout the fixture, or to switch between full on mode, 3.3W mode, and
energy saving mode. Refer to the Operating Instructions section of this manual for details.
•
SELECT PROG (PROGRAM) - Press to scroll through fast fade, fast change, slow fade, and
slow change programs. Press the Speed button, then use the + and - buttons to adjust the pro-
gram speed. Press the Flash button to activate strobing, then use the + and - buttons to adjust the
strobe speed.
•
MANUAL COLOR MODE - Press the R/G/B/A buttons to select one of the four colors. Use the +
and - buttons to adjust the output intensity of each color. This color will now be saved to memory.
When the power is switched off and back on again, the unit will return to this color. Press the
Flash button to activate strobing, then use the + and - buttons to adjust the strobe speed.
•
COLOR SELECT MODE - Press the "1" button to activate color select mode. Use the + and - but-
tons to scroll through the 64 color macros. Press the Flash button to activate strobing, then use
the + and - buttons to adjust the strobe speed.
13
Advertisement
Table of Contents
