Power Cord Daisy Chain; Fuse Replacement; Trouble Shooting; Cleaning - ADJ ENCORE PROFILE 1000 WW User Instructions

POWER CORD DAISY CHAIN

With this feature you can connect the fixtures to one another using the PowerCON input and output
sockets. The quantity that can be connected is 5 fixtures maximum. After 5 fixtures you will need to
use a new power outlet. They must be the same fixtures. DO NOT mix fixtures.

FUSE REPLACEMENT

Disconnect the unit from its power source. Remove the power cord from the unit. Once the cord has been
removed, the fuse holder is located above the powerCON connection. Use a phillips head screwdriver to
remove the fuse holder. Remove the fuse located inside the fuse holder and replace with the new fuse. Install
the fuse holder and new fuse and secure it.

TROUBLE SHOOTING

Listed below are a few common problems the user may encounter, with solutions.
Unit not responding to DMX:
1. Check that the DMX cables are connected properly and are wired correctly (pin 3 is "hot"; on some other
DMX devices pin 2 may be 'hot'). Also, check that all cables are connected to the right connectors; it does
matter which way the inputs and outputs are connected.

CLEANING

Due to fog residue, smoke, and dust cleaning the internal and external optical lenses must be carried out
periodically to optimize light output.
1. Use normal glass cleaner and a soft cloth to wipe down the outside casing.
2. Clean the external optics with glass cleaner and a soft cloth every 20 days.
3. Always be sure to dry all parts completely before plugging the unit back in.
Cleaning frequency depends on the environment in which the fixture operates (i.e. smoke, fog residue, dust,
dew).

SPECIFICATIONS

Model:
Voltage:
LEDs:
Beam Angle:
Working Position:
Power Draw:
Power Cord Daisy Chain:
Fuse:
Weight:
Dimensions:
Colors:
DMX Channels:
Auto Sensing Voltage: This fixture contains an automatic voltage switch, which will auto sense the voltage
when it is plugged into the power source.
Please Note: Specifications and improvements in the design of this unit and this manual are subject to change
without any prior written notice.
A.D.J. Supply Europe B.V. – www.americandj.eu – Encore Profile 1000 WW Instruction Manual Page 13
Encore Profile 1000 WW
100V~240V/50~60Hz
1 x 120W WW COB LED (3200K)
12-30 Degrees
Any safe working position
144W
5 Fixtures Max.
3 Amp.
19 lbs./ 8.5Kgs.
22" (L) x 9.75" (W) x 15.25" (H)
560 x 250 x 385mm
Warm White
3 DMX Modes: 1 Channel Mode, 2 Channel Mode, & 3 Channel
Mode