Testing The Installed Valve - Samson 3241-1-Gas Mounting And Operating Instructions

Installation

5.4 Testing the installed valve

DANGER
!
Risk of bursting due to incorrect opening of
pressurized equipment or components.
Valves and pipelines are pressure equipment
that may burst when handled incorrectly.
Flying projectile fragments or the release of
compressed medium can cause serious in-
jury or even death.
Before working on the control valve:
Î Depressurize all plant sections affected
and the valve (including the actuator).
Release any stored energy.
Î Drain the process medium from all the
plant sections concerned as well as the
valve.
WARNING
!
Risk of personal injury due to pressurized
components and process medium escaping
under pressure.
Î Do not loosen the screw of the test con-
nection while the valve is pressurized.
WARNING
!
Risk of hearing loss or deafness due to loud
noise.
Noise emission (e.g. cavitation or flashing)
may occur during operation caused by the
process medium and the operating condi-
tions. Additionally, a loud noise may briefly
occur through the sudden venting of the
pneumatic actuator or pneumatic valve ac-
5-4
cessories not fitted with noise-reducing fit-
tings. Both can damage hearing.
Î Wear hearing protection when working
near the valve.
WARNING WARNING
! !
Crush hazard arising from actuator and
plug stem moving.
Î Do not insert hands or finger into the
yoke while the air supply is connected to
the actuator.
Î Before working on the control valve, dis-
connect and lock the pneumatic air sup-
ply as well as the control signal.
Î Do not impede the movement of the actu-
ator and plug stem by inserting objects
into the yoke.
Î Before unblocking the actuator and plug
stem after they have become blocked
(e.g. due to seizing up after remaining in
the same position for a long time), re-
lease any stored energy in the actuator
(e.g. spring compression). See associat-
ed actuator documentation.
WARNING WARNING
! !
Risk of personal injury due to exhaust air
being vented.
While the valve is operating, the actuator or
valve accessories may vent during closed-
loop control or when the valve opens or
closes.
Î Wear eye protection when working in
close proximity to the control valve.
EB 8020 EN