NEC UNIVERGE SV8300 Pc Programming Manual page 68

No. Item
(1) Trunk Blade No. field
(2) [Fill In] button
(3) [Clear] button
Select the trunk blade number.
• 000-127
* Unassigned trunk blade number is automatically dis-
played in the Trunk Blade No. field.
Click to apply the settings entered on the first line to other
lines as well.
• Trunk No. field
Trunk numbers are assigned in sequence starting from the
one on the first line.
* Duplicate trunk numbers will be set unconditionally.
Correct those numbers to avoid duplication.
Entry will stop automatically when the trunk number
equals the maximum (511).
• RT No. field
The same value as that appearing on line 1 is set.
* For blades that require a voice channel and a control
channel to be routed separately, route numbers are
assigned automatically.
• TN No. field
The same value as that appearing on line 1 is set.
• Port No. field
Out of the scope of continuous entry.
Click to initialize the settings to their defaults.
4-22
Chapter 4 Standard Mode
[Implement] Category
Description
Continued on next page
NWA-033628-001 Rev.1.0