NEC UNIVERGE SV8300 Pc Programming Manual page 218

Error Message
Errors of communication with
the System occurred.
Confirm the conditions of con-
nection.
Connect to System.
Enter xx Number into the first
line.
Some data is invalid in the first
line.
The data xx has already been reg-
istered.
The data xx is not registered.
Failed to apply the data.
Failed to register the data.
Failed to read the data.
Enter the data.
No data has been registered.
Some data could not be regis-
tered.
Cause
–
There was no connection
with the system when an
attempt was made to read or
write to and from the system.
xx number has not been
entered as a starting line
number.
xx number = Station number,
Trunk number, CS/ZT num-
ber, etc.
Invalid data exists on the
starting line.
–
–
–
–
–
Required data has not been
entered.
–
–
C-6
Appendix C Troubleshooting
Remedial action
Check the status of communica-
tion with the system.
Check the connection with the
system.
Enter xx number as a starting
line number and then click the
[Fill In] button.
Check the data on the starting
line and then click the [Fill In]
button.
Data xx is already registered.
Take either of the following
actions as appropriate:
1. Check the data.
2. Delete the data once and then
register it again.
Register data xx first.
Retry.
Retry.
Retry.
Enter the wanting data.
Register data first.
Retry.
Continued on next page
NWA-033628-001 Rev.1.0