X42 Terminal Strip; Drive-Cliq Interfaces X400, X401, X402 - Siemens SINAMICS S120 Equipment Manual

5.2.3.6

X42 terminal strip

Table 5- 6
Connector
Max. connectable cross-section: 2.5 mm
Note
Connection options for terminal strip X42
The terminal strip is not intended to be freely used for other 24 V DC loads (for example for
supplying additional line-side components), as the voltage supply of the Control Interface
Module could also be overloaded and operating capability could thus be compromised.
5.2.3.7

DRIVE-CLiQ interfaces X400, X401, X402

Table 5- 7
Connector
Blanking plate for DRIVE-CLiQ interfaces (50 pcs.) Article number: 6SL3066-4CA00-0AA0
Air-cooled chassis power units
Manual, 07/2019, 6SL3097-4AE00-0BP9
Terminal strip X42 voltage supply for Control Unit, Sensor Module and Terminal Module
Terminal Function
1 P24L
2
3 M
4
DRIVE-CLiQ interfaces X400, X401, X402
PIN Signal name
1 TXP
2 TXN
3 RXP
4 Reserved, do not use
5 Reserved, do not use
6 RXN
7 Reserved, do not use
8 Reserved, do not use
A + (24 V)
B M (0 V)
Technical specifications
Voltage supply for Control Unit, Sensor Module and
Terminal Module (18 to 28.8 V)
maximum load current: 3 A
2
Line Modules
5.2 Basic Line Modules
Technical specifications
Transmit data +
Transmit data -
Receive data +
Receive data -
24 V power supply
Electronics ground
137