Installing The Braking Module In A Basic Line Module, Frame Size Fb - Siemens SINAMICS S120 Equipment Manual

Air-cooled chassis power units

Hide thumbs Also See for SINAMICS S120:

Table of Contents

Installing the Braking Module in a Basic Line Module, frame size FB

Installing the Braking Module

The steps for the installation procedure are numbered in accordance with the diagram.

1. Unscrew the three screws of the blanking plate.

Remove the plate.

2. Insert the Braking Module where the cover used to be and secure it using the three

screws (from step 1).

3. Attach the adapter bar to the DCNA using a nut, so that the busbar cannot be twisted. For

this purpose, a small bolt is attached to the adapter bar, which must be located on the

lower side of the DCNA connection.

4. Secure the connecting cable to the DC link with two screws (Braking Module connection)

and two nuts (DC-link connection).

Air-cooled chassis power units

Manual, 07/2019, 6SL3097-4AE00-0BP9

Installing the Braking Module in a Basic Line Module, frame size FB

DC link components

8.1 Braking Module

Table of Contents