Figure 8-9
Installing the Braking Module
The steps for the installation procedure are numbered in accordance with the diagrams in
front of them.
1. Unscrew the two M6 screws from the front cover and lift off the cover.
2. Unscrew the two screws from the upper cover plate.
Loosen the M6 nut on the left.
Remove the left cover
3. Unscrew the four screws from the upper cover plate.
Unscrew the three screws from the rear cut-out sections.
Remove the top covers.
Air-cooled chassis power units
Manual, 07/2019, 6SL3097-4AE00-0BP9
Installing the Braking Module in a Smart Line Module / Active Line Module / Motor
Module, frame size GX – steps 4 - 6
DC link components
8.1 Braking Module
335