Overall Dimension And Panel Cutout - Smartgen HGM6100N Series User Manual

Note: Recommend that the output of crank and Fuel expand high capacity relay.
12 INSTALLATION
12.1 FIXING CLIPS
The module is held into the panel fascia using the supplied fixing clips.
— Withdraw the fixing clip screw (turn anticlockwise) until it reaches proper position.
— Pull the fixing clip backwards (towards the back of the module) ensuring four clips are inside their
allotted slots.
— Turn the fixing clip screws clockwise until they make contact with the panel.
— Care should be taken not to over tighten the screws of fixing clips.

12.2 OVERALL DIMENSION AND PANEL CUTOUT

HGM6100N Genset Controller
HGM6100N Series Genset Controller User Manual
Fig. 9 - Single Phase 2 Wire
Fig. 10 - 2 Phase 3 Wire
Fig.11 – Case and Overall Dimensions
2019-03-28 Version 1.5 Page 32 of 42