Workshop manual
aSSemBlING THe eNGINe
- Block the rotation of the crankshaft sprocket and tighten the nut (arrow).
Tightening torque: 40 Nm.
FITTING THE GEAR SELECTOR ASSEMBLY
- Fit the gear selector assembly with the spring (arrow) untensioned and tighten
screw -1-
Use threadlocker.
Tightening torque: 6 Nm.
1
- Position the spring (arrow) with a pair of pliers.
- Fit selector shaft centring screw -2-. Use threadlocker. Tightening torque: 15 Nm.
2
- Insert the selector shaft and fit the entire selector shaft (arrow).
-62-