Workshop manual
aSSemBlING THe eNGINe
1
FITTING THE IGNITION
2
- Fit the crankshaft cotter pin.
- Position the ignition stator and screws (arrows)
- Tighten the screws (arrows). Use threadlocker. Tightening torque: 8 Nm.
- Make sure rubber cap -2- is correctly positioned.
- Fit the magnetic flywheel and tighten nut -1-. Use threadlocker.
Tightening torque: 40 Nm.
- Fit a new gasket to the ignition cover and tighten the screws (arrows).
- Fit the spark plug to the cylinder head.
Attention:
T hesparkplugmustalwaysbescrewedinbyhandasfarasitwillgoand
thengentlytightenedwithasparkplugspanner!
Tightening torque: 27 Nm.
-67-