Left-Hand Semi-Crankcase, Outer Side - GAS GAS Enduro Series Workshop Manual

Workshop manual
SeRVICING aND RePaIRING THe eNGINe'S COmPONeNTS
Photo missing
1
1
- Check the lubrication hole of the crankshaft bearing (arrow). It should be clean
and free of obstructions.

LEFT-HAND SEMI-CRANKCASE, OUTER SIDE

Note:
Allgaskets,sealsandO-ringsmustbereplacedeverytimetheengineis
partiallyorcompletelydismantled.
Crankshaft seal -1-
- Place the new crankshaft seal in the semi-crankcase housing. The sealing lip
must be orientated towards the outside of the semi-crankcase.
- Press on the seal with a pusher until it is fully encased in the left-hand semi-
2
crankcase housing.
Attention:
3
Whenfittingtheseal,becarefulnottodamagethesealinglip!
Output shaft seal -2-
- Place the new crankshaft seal in the semi-crankcase housing. The sealing lip
must be orientated towards the outside of the semi-crankcase.
- Press on the seal with a pusher until it is flush in the left-hand semi-crankcase
2
housing.
3
Attention:
Whenfittingtheseal,becarefulnottodamagethesealinglip!
Selector shaft seal -3-
- Fit the new selector shaft seal to the semi-crankcase housing. The sealing lip
must be orientated towards the outside of the semi-crankcase.
- Press on the seal with a pusher until it is fully encased in the left-hand semi-
crankcase housing.
Attention:
Whenfittingtheseal,becarefulnottodamagethesealinglip!
-42-