Workshop manual
aSSemBlING THe eNGINe
FITTING THE CLUTCH COVER
1
1
- Fit the new clutch cover gasket.
- Fit the clutch cover and tighten the screws diagonally.
5
Screws -1- : 30 mm.
2
Screws -2- : 35 mm.
2
Screws -3- : 55 mm.
2
Tightening torque: 10 Nm.
5
- Fit a new gasket to the clutch disc cover and tighten the screws diagonally.
2
Screws 4: 25 mm.
1
Screws 5: 75 mm.
Tightening torque: 10 Nm.
FITTING THE WATER PUMP
- Fit the new water pump seal (arrow) to the clutch cover.
- Position water pump turbine -1- and insert fixing screw -2-.
- Block the rotation of the turbine and tighten screw -2-. Use threadlocker.
Tightening torque: 6 Nm.
2
1
- Fit the water pump cover and tighten the screws (arrows).
Tightening torque: 6 Nm.
-66-