Right-Hand Semi-Crankcase, Outer Side - GAS GAS Enduro Series Workshop Manual

Workshop manual
SeRVICING aND RePaIRING THe eNGINe'S COmPONeNTS
- Press on the bearing until it is fully encased in the right-hand semi-crankcase
housing.
Attention:
Whenremovingandfittingtheneedlerollerbearing,becarefulnottoapply
excessivepressuretothebearinghousingarea.Ifthepressureisexcessive,
thesemi-crankcasemaybecomedamaged!
- Check the lubrication hole of the crankshaft bearing (arrow). It should be clean
and free of obstructions.

RIGHT-HAND SEMI-CRANKCASE, OUTER SIDE

Note:
Toremovethebearingsfromtheright-handsemi-crankcase,itisnecessaryto
heatittoapproximately150°Cusingaheatingplate,stoveorsimilar.Onceit
ishot,simplyuseanordinaryextractortoolorasoftmetalorwoodenpusher
toremovethebearingscompletely.Inexceptionalcases,itmaybenecessary
to use a press to dislodge the bearings.
- Remove the seals from the right-hand semi-crankcase using a seal extractor or
by carefully prying with a screwdriver.
Note:
Allgaskets,sealsandO-ringsmustbereplacedeverytimetheengineis
partiallyorcompletelydismantled.
- Place the right-hand semi-crankcase on a heating plate and heat it to
approximately 150°C.
Danger:
Whenhandlingthesemi-crankcaseafterheatingit,heat-resistantgloves
should be worn to protect the hands.
- Dislodge the bearings from the right-hand semi-crankcase.
-38-