Table of Contents
Advertisement
AS-i Speed Monitor
Configuration
8.
Configuration
Parameters are set similar to the AS-i Safety Monitor using the PC interface and
reading back the data per text. Communication between the Speed Monitor and
the PC is over AS-i.
8.1
Parameters
VBA-2E-KE4-ENC-S
Each channel uses the following parameters:
•
AS-i Address
•
Channel activated, channel not activated
•
Detection of Safety Stop active, detection of Safety Stop not active
•
Maximum allowed safe speed
•
Detection of rotating direction.
VBA-2E2A-KE4-ENC/SSI-S
There are following parameters for each channel:
•
AS-i Address
•
Type of encoder
•
Encoder parameters
•
Filter settings
•
safe coupling of encoder.
The function of the safe AS-i signals and the safety outputs can be freely config-
ured via the ASIMON software.
Information!
For additional information, please refer to the separate documentation for the ASIMON
software.
8.2
Setting parameters using AS-i Master with integrated Safety Monitor
Information!
Setting parameters using AS-i Master with integrated Safety Monitor is only possible
with VBA-2E-KE4-ENC-S .
1.
The Speed Monitor is connected to the AS-i circuit.
2.
The non-safety slave is addressed.
3.
The connected axes are brought to safe speed. If multiple Speed Monitors
are connected, the Projecting button is actuated. The CONF LED flashes.
4.
From the menu select "Speed Monitor." If multiple Speed Monitors are con-
nected, you can select which device (AS-i address of the non-safety slave)
is parameterized.
5.
This menu is displayed
26
Advertisement
Table of Contents
