Pepperl+Fuchs AS-i Manual page 17

AS-i Speed Monitor
Product Description
VBA-2E2A-KE4-ENC/SSI-S
By short pushing the Projecting button, the global reset of error condition can be
triggered, in order to reset red-flashing configuration devices or an output that has
shut down because of an overload.
• If no error is present, currently available frequencies and/or positions can be
stored temporary for processing. These values can then be uploaded via soft-
ware.
• The Projecting button can be used to reset the device to its default settings:
Mode for factory settings (VBA-2E2A-KE4-ENC/SSI-S)
Disconnect AS-i voltage.

Push and hold the Projecting button.

Holding the button, connect the AS-i voltage again.


A running light on LEDs ST1, ST2, F1 and F2 appears for 5 seconds.
After the running light is started, release the button and confirm the process

with short pushing the button.

The device is set to the factory settings.

The device is in configuration mode.
17