Chip Card; Sensors - Pepperl+Fuchs AS-i Manual

AS-i Speed Monitor
Product Description
5.5.3

Chip card

The chip card is used for storing the device parameters, speeding up the time re-
quired to replace defective units. Exchanging the chip card moves all parameters
from the old unit to the new one.
Unit replacement: Chip card "not blank" in a non-configured unit (unit in
factory default state)
If a non-blank chip card is plugged into a configured unit, the data are copied to
the unit.
Blank chip card in a configured unit
If a blank chip card is plugged into a configured unit, the data are copied to the
chip card.
Data in the unit and the chip card are not the same
If the chip card and the unit are not blank and contain different data, there will be
an error message (see Sec. <LEDs>).
Warning!
Verify the safety functions after replacing the unit!
5.5.4

Sensors

To VBA-2E-KE4-ENC-S only rotary and linear encoders may be connected.
To VBA-2E2A-KE4-ENC/SSI-S also angle or position encoder can be connected
next to rotary or linear encoders.
Information!
Please note additional information in Sec. <Safety Requirements>.
18