Installation - EMS EMS560 User Manual

Installation

Upon receipt, check for any visible damage which may have occurred in
transit. If any signs of damage are found then retain all packing material
and inform the carrier and the Company or its agent from whom the unit
was purchased.
The Primo radial shockwave must only be used with an EMS559 power
supply (as supplied with the unit). The cord coming from the back of the
main shockwave unit plugs into the circular connector on the back of the
power supply. A power cord appropriately rated/approved for the country of
use must be used.
The EMS559 power supply must only be connected to a mains supply with
a protective earth conductor. If the integrity of the earth connection is in
doubt, do not connect it to the mains supply (risk of electric shock with type
B applied parts). The unit must not be positioned in such a way that the
mains plug cannot easily be unplugged – the mains plug is the main
disconnect device.
The Primo radial shockwave 560 unit is supplied with a shockwave
applicator and a foot (or hand) operated switch.
Plug the applicator into the output socket on the front right of the unit and
the foot-switch into the socket to the front left.
Be careful not to subject the applicator to rough handling such as dropping
onto a hard surface as this may impair performance.
Primo radial shockwave 560 – OM560EN Iss 3
14