Installation - EMS COMBINATION 850 Manual

Installation

Upon receipt, check for any visible damage which may have occurred in transit.
If any signs of damage are found then retain all packing material and inform
the carrier and the Company or its agent from whom the system was purchased.
If not already fitted, connect a suitable plug to the mains cable. The plug must
have provision for an EARTH (GROUND) connection. The mains cable has the
following colour code, BROWN is LIVE (LINE), BLUE is NEUTRAL and
GREEN/YELLOW is EARTH.
Attach the carrying handle to the right hand side of the unit. This is done by
locating the key-hole slots in the handle on the three fixings at the right hand
side of the unit and pushing the handle down until it "clicks" into position. The
handle release button prevents the handle being removed inadvertently. To
remove the handle, press the release button away from the unit and pull the
handle upwards.
Connect the mains cable to the IEC socket on the rear of the unit and to a
suitable power outlet.
2 2
Connect the 5 cm or 0.5 cm ultrasound transducer to the ultrasound output
socket. When inserting the plug make sure that it is correctly aligned with the
socket. The plug has a locking ring to make sure that the transducer is not
disconnected inadvertently. The transducer may be stored in the holder in the
2 2
carrying handle: 5 cm transducer at the rear, 0.5 cm transducer at the front.
The active face of each transducer is fitted with a protective label prior to
shipment and this must be removed before the ultrasound transducer is used.
Connect either the 4-way or 2-way patient lead to the interferential output
socket. When inserting the plug make sure that it is correctly aligned with the
socket. The plug has a locking ring to make sure that it is not disconnected
inadvertently.
COMBINATION 850 24 ISSUE 2