Operating Instructions - EMS EMS560 User Manual

Operating instructions

Power on sequence and general information
After the Primo radial shockwave 560 is turned on using the mains switch
on the back of the PSU unit a splash screen appears showing the EMS
company logo.
After a few seconds the unit will give a short beep and display the main
screen.
The main counter (top middle window) reads zero as no shocks have been
produced yet, also a default number of 300 shocks is ready to go but as
none have been triggered yet the usage graphic shows 0%.
Standard user controls
Throughout the operation of the Primo radial shockwave 560 the various
modes and parameter settings are all accessed and changed by touching
the relevant buttons displayed on the touchscreen.
On most display screens touching the back arrow icon in the top left corner
will return the display to the main Home screen.
The on/off button at the bottom right of the top panel can be used to turn off
the display and put the unit into standby mode, pressing it again switches it
16 Primo radial shockwave 560 – OM560EN Iss 3