EMS EMS560 User Manual page 19

The energy density per shock depends on the energy per shock (set by the
+ and – buttons) and the size of the applicator tip used (selected by the
button with the applicator tip icon). It is automatically calculated from the
energy per shock (in mJ) divided by the surface area of the selected tip (in
2
mm ). The tip select button should of course always be set to the size
actually in use on the applicator.
The 'Freq' button will select between the four available shock frequencies -
the defaults of these are 8Hz, 10Hz, 15Hz and 22Hz.
The 'Burst' button toggle between normal (continuous pulses for as long as
the foot switch is held on) and burst modes, where the default* burst is 8
pulses for every foot switch press. In burst mode it is necessary to keep
pressing and releasing the foot switch to get each burst.
The 'Treatments' button, when pressed, opens this screen –
Touching the back-arrow icon in the top left will return us to the main
screen.
Pressing a button on the treatments screen takes us back to a main screen
with the stored parameter settings. If it was a 'treatment suggestion' button
the condition title will be shown in the bottom-right corner, and the default
settings for that condition will be loaded. Parameters are still adjustable as
the user may wish to 'ramp up' the shock energy or frequency during a
treatment session, but any changes will not be saved.
Primo radial shockwave 560 – OM560EN Iss 3
19