Installation And Set Up; (Typical Is Shown); Installation Et Branchement; Installation Und Einrichtung - EMS AIR-FLOW handy 2+ Operation Instructions Manual

Hide thumbs Also See for AIR-FLOW handy 2+:
Table of Contents

Advertisement

INSTALLATION AND SET UP

Checking the turbine connection

(typical is shown)

The device is equipped with a connector
specially designed for the turbine connection
of your dental unit. Only use the device with
this special turbine connection. To connect it to
another type of turbine will damage it.
The turbine of your dental unit must not be
under pressure when connecting the device. Do
not activate the turbine footpedal. If you have a
turbine equipped with light, turn the light off.
Make sure the O-rings of your turbine
connection are in good condition. A turbine
connection with O-rings in bad condition can
damage the device.
6
FB-213_3_rev_A-01_Handy 2+.indd 6
INSTALLATION ET
BRANCHEMENT
Vérification du raccord de turbine
(raccord type illustré)
L'appareil est équipé d'un connecteur
spécifique correspondant au raccord de turbine
présent sur votre unit dentaire. Utiliser l'appareil
seulement avec son raccord de turbine spéci-
fique. Le brancher sur un autre raccord de turbine
l'endommagerait.
La turbine de votre unit dentaire ne doit
pas être sous pression pour connecter l'appareil.
Ne pas actionner la pédale de commande de
la turbine. Si vous disposez d'une turbine avec
lumière, éteindre la lumière.
Vérifier que les O-rings de votre raccord de
turbine sont en bon état. Un raccord de turbine
avec des O-rings en mauvais état peut endom-
mager l'appareil.
INSTALLATION UND
EINRICHTUNG
Überprüfen des Turbinenanschlusses

(typischer Anschluss siehe Abbildung)

Das Gerät ist mit einem Adapter ausge-
rüstet, der für den Turbinenanschluss Ihres
zahnmedizinischen Gerätes bestimmt ist.
Benutzen Sie das Gerät nur mit diesem Adapter.
Andernfalls wird es beschädigt.
Um Ihr Gerät anzuschliessen, darf Ihre
zahnmedizinische Behandlungseinheit nicht
druckbeaufschlagt sein. Betätigen Sie nicht den
Fussanlasser der Turbine. Wenn Sie über eine
Turbine mit Licht verfügen, schalten Sie bitte das
Licht aus.
Achten Sie darauf, dass sich die O-Ringe
Ihres Turbinenanschlusses in gutem Zustand
befinden. Defekte O-Ringe am Turbinenan-
schluss können zu Schäden am Gerät führen.
11.04.2017 14:36:31

Advertisement

Table of Contents
loading

Table of Contents