Configuring General Parameters; Configuring The General Servo Fields - Deif IMD 100 Series Integration Manual

IMD 100 Integration manual 4189360015 Rev. G

8.4 Configuring general parameters

The general parameters are configured in the "Configuration 1/3" tab.

8.4.1 Configuring the general servo fields

The "Servo" fields are general configurations of the IMD. The red dashed rectangle in the following
figure shows the parameters that are to be configured.
Figure 37 Servo data in IMD Manager configuration 1/3
Fill in the following fields:
•
Axis label: The label is an optional parameter that can be used to differentiate between different
IMDs. Up to 4 characters can be used. The label is also shown at the right bottom of the IMD
Manager as well:
•
Mains: Mains voltage. Enter the nominal voltage used.
www.deif.com/wind-power
IMD configuration
Page 81 of 243