Configuring Additional Motor Parameters - Deif IMD 100 Series Integration Manual

IMD 100 Integration manual 4189360015 Rev. G
10. Save the configuration to the EEPROM (see IMD Manager user manual).

8.6.2 Configuring additional motor parameters

Attention
If the motor type is Sync. Servo, all configurable parameters in "Additional motor
parameters" must be set to zero.
The additional motor parameters are the electrical properties of the motor. There are two ways this
can be done:
•
Enter the data from the data sheet manually (if available). If this is done, "L sigma-q" value must be
filled before "L sigma-d" value.
•
Use the automatic calculation procedure (calculates the parameter values using data from the
name plate).
The following procedure describes how to use the automatic calibration procedure.
8.6.2.1 Prerequisites
Before configuring the additional parameters all the fields in the "Motor data" group in "Configuration
1/3" tab must be filled.
8.6.2.2 Calculation procedure
1. Select "[Fn8] Calc from motor nameplate" in the "Special function" group in the "Configuration 3/3"
tab.
2. Click on "START" button
www.deif.com/wind-power
IMD configuration
Page 118 of 243