Configuring The Charger Manually - Deif IMD 100 Series Integration Manual

IMD 100 Integration manual 4189360015 Rev. G

8.7.3 Configuring the charger manually

The charger has 2 parameter types:
•
Basic parameters: Must always be configured.
•
Parameter configuration: Can either be configured manually or used with the factory defaults
(select with the "Set factory default" button). There is a set of factory defaults parameters for each
SE type.
NOTE To achieve maximum performance and life time of the energy source, consult the energy
source supplier, and have the applicable charging characteristics at hand.
8.7.3.1 Configuring type and basic configuration
1. Click on the "SE charger" tab. If the Setup mode is disabled (
"Disabled" button to enable the Setup mode.
www.deif.com/wind-power
IMD configuration
) click on the
Page 122 of 243