Solaris Issues Fixed In Solaris 10 5/08 - Sun Microsystems SPARC Enterprise M8000 Product Notes

Xcp version 1091
Hide thumbs Also See for SPARC Enterprise M8000:
Table of Contents

Advertisement

Solaris Issues Fixed in Solaris 10 5/08

TABLE 3-6
encounter them in earlier releases.
Solaris OS Issues and Workarounds Fixed in Solaris 10 5/08 (1 of 4)
TABLE 3-6
CR ID
Description
5076574
A PCIe error can lead to an invalid fault
diagnosis on a large M8000/M9000 domain.
6348554
Using the cfgadm -c disconnect
command on the following cards might hang
the command:
• SG-XPCIE2FC-QF4, Sun StorageTek
Enterprise Class 4-Gigabit Dual-Port Fiber
Channel PCI-E HBA
• SG-XPCIE1FC-QF4, Sun StorageTek
Enterprise Class 4-Gigabit Single-Port Fiber
Channel PCI-E HBA
• SG-XPCI2FC-QF4, Sun StorageTek
Enterprise Class 4-Gigabit Dual-Port Fiber
Channel PCI-X HBA
• SG-XPCI1FC-QF4, Sun StorageTek
Enterprise Class 4-Gigabit Single-Port Fiber
Channel PCI-X HBA
6402328
Customers using more than six IOUA (Base
I/O Card) cards in a single domain might
experience panic during a period of high I/O
stress.
6472153
If you create a Solaris Flash archive on a sun4u
server other than an
M4000/M5000/M8000/M9000 server, then
install it on one of these servers, the console's
TTY flags will not be set correctly. This can
cause the console to lose characters during
stress.
6505921
Correctable error on the system PCIe bus
controller generates an invalid fault.
lists issues that have been fixed in the Solaris 10 5/08 OS. You might
Workaround
Create a file /etc/fm/fmd/fmd.conf
containing the following lines;
setprop client.buflim 40m
setprop client.memlim 40m
Do not perform
cfgadm -c disconnect
operation on the affected cards.
Limit the maximum number of IOUAs in a
single domain to 6.
Just after installing Solaris OS from a Solaris
Flash archive, telnet into the
M4000/M5000/M8000/M9000 server to reset
the console's TTY flags as follows:
# sttydefs -r console
# sttydefs -a console -i "9600 hupcl
opost onlcr crtscts" -f "9600"
This procedure is required only once.
Create a file /etc/fm/fmd/fmd.conf
containing the following lines;
setprop client.buflim 40m
setprop client.memlim 40m
Chapter 3
Information About Software
47

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sparc enterprise m9000

Table of Contents