Solaris Issues Fixed In Solaris 10 5/08 - Sun Microsystems SPARC Enterprise M8000 Product Notes

Solaris Issues Fixed in Solaris 10 5/08

TABLE 6
them in supported releases earlier than Solaris 10 5/08.
Solaris OS Issues and Workarounds Fixed in Solaris 10 5/08 (1 of 4)
TABLE 6
CR ID Description
5076574 A PCIe error can lead to an invalid fault
diagnosis on a large M9000/M8000 domain.
6348554 Using the cfgadm -c disconnect
command on the following cards might hang
the command:
• SG-XPCIE2FC-QF4
Enterprise Class 4Gb Dual-Port Fibre
Channel PCI-E HBA
• SG-XPCIE1FC-QF4
Enterprise Class 4Gb Single-Port Fibre
Channel PCI-E HBA
• SG-XPCI2FC-QF4
Enterprise Class 4Gb Dual-Port Fibre
Channel PCI-X HBA
• SG-XPCI1FC-QF4
Enterprise Class 4Gb Single-Port Fibre
Channel PCI-X HBA
6472153 If you create a Solaris Flash archive on a non-
Sun SPARC Enterprise M8000/M9000 sun4u
server and install it on a Sun SPARC Enterprise
M8000/M9000 sun4u server, the console's TTY
flags will not be set correctly. This can cause
the console to lose characters during stress.
6522433 The incorrect motherboard might be identified
by fmdump for cpu faults after reboot.
6527811 The showhardconf(8) command on the XSCF
cannot display PCI card information that is
installed in the External I/O Expansion Unit, if
the External I/O Expansion Unit is configured
using PCI hot-plug.
lists issues that have been fixed in Solaris 10 5/08 OS. You might encounter
Sun StorageTek
Sun StorageTek
Sun StorageTek
Sun StorageTek
Sun SPARC Enterprise M8000/M9000 Servers Product Notes
Workaround
Create a file /etc/fm/fmd/fmd.conf
containing the following lines;
setprop client.buflim 40m
setprop client.memlim 40m
Do not perform cfgadm -c disconnect
operation on the affected cards.
Just after installing Solaris OS from a Solaris
Flash archive, telnet into the Sun SPARC
Enterprise M8000/M9000 server to reset the
console's TTY flags as follows:
# sttydefs -r console
# sttydefs -a console -i "9600 hupcl
opost onlcr crtscts" -f "9600"
This procedure is required only once.
None at this time.
There is no workaround. When each PCI card in
the External I/O Expansion Unit is configured
using PCI hot-plug, the PCI card information is
displayed correctly.
15