Documentation Updates - Sun Microsystems SPARC Enterprise M8000 Product Notes

Documentation Updates

This section contains late-breaking information that became known after the
documentation set was published, or that was very recently added.
Documentation Updates
TABLE 3-8
Document
SPARC Enterprise
M3000/M4000/M5000/
M8000/M9000 Servers XSCF
Reference Manual and XSCF
man pages
54 Sun SPARC Enterprise M8000/M9000 Servers Product Notes for XCP 1091 • May 2010
Issue
setdualpowerfeed(8)
setupfru(8)
showdevices(8)
showenvironment(8)
Change
The following description was added to
DESCRIPTION in the XCP 1091 release:
The dual power feed mode cannot be used with 100V
power on M4000/M5000 servers.
The following description was added to EXTENDED
DESCRIPTION in the XCP 1091 release:
Although a CMU with two CPUMs can be configured
into Quad-XSB mode on an M8000/M9000 server, the
server generates a "configuration error" message for
those XCBs that do not have a CPUM and memory.
The following information was added in the XCP 1091
release:
After a DR operation and subsequent domain power
cycle, you must run the command devfsadm -v
command before running showdevices. Otherwise,
the resulting display from showdevices will be
erroneous.
The following information was added in the XCP 1091
release:
The power operand is supported only on M3000
servers, and the air operand is supported only on
M3000/M8000/M9000 servers.