Solaris Issues Fixed In Solaris 10 5/09 - Sun Microsystems SPARC Enterprise M8000 Product Notes

Solaris Issues Fixed in Solaris 10 5/09

TABLE 3-4
encounter them in earlier releases
Solaris OS Issues and Workarounds Fixed in Solaris 10 5/09
TABLE 3-4
CR ID Description
6588555 Resetting the XSCF during a DR operation on
permanent memory might cause domain panic.
6623226 The Solaris command lockstat(1M) or the
dtrace lockstat provider might cause a system
panic.
6680733 Sun Quad-port Gigabit Ethernet Adapter UTP
(QGC) & Sun Dual 10 GigE Fiber XFP Low
Profile Adapter (XGF) NICs might panic under
high load conditions.
6689757 Sun Dual 10 GigE Fiber XFP Low Profile
Adapter (XGF) with a single or improperly
installed XFP optical transceivers might cause
the following error to show on the console:
The XFP optical transceiver is broken
or missing.
lists issues that have been fixed in the Solaris 10 5/09 OS. You might
Workaround
Do not start an XSCF reset while a DR operation
is underway. Wait for the DR operation to
complete before starting the reset.
Do not use the Solaris lockstat(1M)
command or the dtrace lockstat provider.
If posible, use the card in x8 slot. Otherise, there
is no workaround.
Check and make sure that both XFP optical
transceivers are firmly seated in the housing.
Do not mix INTEL and Sun XFP optical
transceivers in the same Adapter.
Do NOT plumb a port with the ifconfig
command if the port does not contain an XFP
optical transceiver or it contains one but the
transceiver is not in use.
Chapter 3 Information About Software 43