Table of Contents
Advertisement
Power-off procedure
1
SHUTTING DOWN...
PLEASE WAIT
The message shown above is displayed on the LCD to indicate that the shutdown process is being executed. The power
turns off after the shutdown procedure is finished.
However, maintenance operations are automatically performed to maintain the printer in good condition. Therefore,
always keep the power of the printer on.
If you need to temporarily turn the printer off in case of emergency, for cleaning, or other reasons, use one of the following
methods to turn it off.
Method 1:
Keep the power switch pressed for 2
seconds.
Method 2:
Keep the power switch pressed for 2
seconds while holding the CANCEL button.
Notes
‹ After turning the power off, wait at least 5 seconds before turning it back on.
‹ To keep the print heads in good condition, the printer perform automatically and periodically the fill cap operation while in
standby mode. It is recommended to keep on the power switch on the operation panel during this operation.
34
Before printing
To turn off the power of the printer, keep the
power switch on the operation panel pressed
for 2 seconds.
Usually, use this method to turn the printer off. During
shutdown, the fill cap operation (state where the cap is
filled with ink) is performed to keep the print heads in
good condition.
This method can be used to turn the printer off only for a
short time (less than 1 hour). With this method, the fill cap
operation is skipped and the printer is turned off.
Advertisement
Table of Contents
